A.O. Smith Jaguar CEWHR, Руководство пользователя

Страница: 11 / 20

7
The power cord and plug have been equipped and connected well with this water heater. Just plug it into
a corresponding socket.
Attention: Please make sure the water heater and the socket are appropriately grounded. A separate
socket should be used. Moreover, the socket must be of a good quality to ensure proper
contact with the plug. The rated current of the socket should not be less than 15A.
Electrical Power Wiring
Once the piping has been connected, open the cold water valve and hot water faucet to fill the water
heater and drain the air out until water flows continuously from hot water faucet. This indicates that the
heater is full. Then, close the hot water faucet and check all the connections to see if there is any leakage.
If it leaks, drain the heater completely, repair the leaking joint and then re-fill the heater.
Water Filling
Black
If the remote wire is to be installed on the wall by wire slot or wire clip, the control box will be
installed on the surface of the wall by box hanger which has been fixed on the wall previously
.
If
the remote wire is prepared to be embedded into the wall through wire tube
,
the installation
operation will be as follows:
1 First, unscrew the four screws in the box and open the box.
2 Second, take out the remote wire and pull it out from the wire terminal.
3 Third, put the wire through the wire tube in the wall (take care so as not to damage the eight-core
plug and wire) and plug the eight-core wire terminal into the controller.
4 Lastly, close the control box cover with screws and fix it onto the pre-installed fixed board on the wall.
Control Box Connection