A.O. Smith Jaguar CEWHR, Руководство пользователя

Страница: 10 / 20

6
Connect the pressure-relief safety valve in the water inlet (on the side of the blue plug cap) in the
direction of the arrow pointing in the direction of water flow (i.e. pointing to the water heater). Connect
hot water pipe to the outlet (on the side of the red plug cap). See
above content on safety valve for
the installation of the safety valve. In case, the water pressure is close to over the safety valve
rating (0.8Mpa), please install a pressure-reducing valve in the inlet piping with sufficient distance
from the heater. Refer to the below diagram for water connection details.
Attention
:
Make sure a suitable tape thread sealant is used for all connections to prevent leakage
.
Meanwhile, the safety valve must not be excessively tightened so as to prevent damage
.
Plumbing
Black
1. Make necessary plumbing with reference to the below diagram.
2. It is recommended that suitable nylon braided hoses should be used. These hoses should have a
minimum pressure rating of 8 Bar and should be compatible for hot water applications.
3. Connect the cold water pipe to the inlet [blue].
4. Connect the hot water pipe to the outlet [red].
Attention: Make sure a suitable sealing tape is used for all connections to prevent leakage. Meanwhile,
the safety valve must not be screwed too tight to prevent damage.
Water Connection
Cold Water Inlet
Handle
Discharge Pipe [Connected to Drain Pipe]
Safety Valve
Hot Water Outlet