UNIVERSAL TOASTER UTX-200
12
P/N 1010904 Rev. 14 04/06
McDonald’s
OPERATION (continued)
Purging Products from the Toaster
During normal operation, it may become necessary to
purge a product from the toaster.
NOTE: The unit must be in a READY or WAIT mode
in order to purge products.
There are two ways to purge products from the unit:
1.
FACING FRONT OF UNIT
:
With the unit in a READY or WAIT mode, open
the front Cover. Press and hold the
NEXT
arrow
button until the product is purged from the unit.
Once the product is purged, release the
NEXT
arrow button and the unit will return to normal
operating speed.
2.
FACING REAR OF UNIT
:
With the unit in a READY or WAIT mode, you
can also press and hold BOTH of the
MUFFIN/
BAGEL
buttons together to purge product from
the unit. These buttons are located at the rear of
the unit.
Once the product is purged, release both
MUFFIN/BAGEL
buttons
These procedures temporarily speed up the unit to
purge products out to the front of the toaster.
NOTE: Product is always purged out of the front
of the Toaster using the NEXT arrow button or the
MUFFIN/BAGEL buttons. It is NOT possible to
purge product backwards through the unit. Only
the NEXT arrow button or the MUFFIN/BAGEL but-
tons will purge product from the unit.
Shutting down the UTX-200
Follow these steps to shut down the toaster:
1. Turn the Rocker Switch (power On/Off) to OFF.
The red light on the switch will turn off.
2. The fans will continue to run with the display read-
ing
Cleaning Mode
. The Cleaning Mode will
continue for 45 minutes and completely shut the
unit down automatically when complete.
NOTE: If the unit requires any internal maintenance,
be sure to completely shut down the unit.
WARNING
To avoid possible personal injury and/or dam-
age to the unit, all inspections, tests, and repair
of electrical equipment should be performed
by QUALIFIED SERVICE PERSONNEL. The unit
MUST be completely shut down and unplugged
before performing any internal service, except
when electrical tests are required. Use extreme
care during electrical circuit tests. Live circuits
will be exposed.
Outside Position for
Odd Numbered Days
Inside Position For
Even Numbered Days
Retainer Bar
Extention
Retainer Bar
Extention
Rotating the Release Sheet
It is important to both clean and use BOTH Sides of the
Release Sheet. This will double the life of the sheet.
The Release Sheet should be rotated from side to side
each day of operation.
The Release Sheet Retainer Bar can be used as a
means to track Release Sheet rotation. Refer to Figure
3. The Release Sheet should be installed with the
Release Sheet Retainer Bar Extension pointing to the
“
OUTSIDE
” (so that it’s visible) on
ODD
numbered days
of the month.
The Release Sheet should be rotated so that the
Release Sheet Retainer Bar Extension is pointing to the
“
INSIDE
” on
EVEN
numbered days of the month.
NOTE: During future cleaning, leave the Release
Sheet on the Release Sheet Retainer Bar as a
reminder for proper rotation.