A.J.Antunes 9100320, Руководство пользователя

Страница: 10 / 24

10
P/N 1010751 Rev. G 01/08
McDonald’s
Multi-purpose steaMer - Mps-250
ProGraMMiNG
CYC (total Cycle time) refers to the total amount of
cooking time set for the product on any particular menu
channel.
rate (shot interval time) is the time set between
shots of steam during a complete cycle.
shot (steam shot time) is used to adjust the water
volume during each solenoid operation, or “shot” of
steam.
The amount of steam produced by your unit depends
on the amount of water sprayed onto the steam
Generator.
Flooding of the Generator may occur if the H
2
O setting
(SHOT) is set too high. To prevent this from occur-
ring, the Shot Interval Time (RATE) could be increased
to allow more time for Generator recovery, and/or
the Steam Shot Time (SHOT) could be decreased to
reduce water volume. Adjustments should be made to
both values to determine the optimum settings for your
cooking needs.
NOTE: CYC, RATE and SHOT are sequential opera -
tion per channel for all programming. (You must
perform all steps for CYC and rate to only change
shot).
To program the control, refer to Figure 5 and use the
following procedure in sequence:
CYC (total Cycle time)
1. Turn the power on.
2. Press the PROGRAM button (Figure 4) to change
the control from OPERATION to PROGRAM
mode. The default setting will appear in the
display (Figure 5, Item A).
Note: if no change is made within 10 seconds
at any time during the programming process, all
changes made up to that point are stored in memory
and the control reverts to oPeratioN mode.
3. Press the UP or DOWN arrow buttons to change
the total cycle time in minutes (Figure 5, Item B).
4. Press the PROGRAM button again, then use the
UP or DOWN arrow buttons to change the total
cycle time in seconds (Figure 5, Item C).
rate (shot interval time)
5. Press the PROGRAM button again, then Press
both UP and DOWN arrow keys simultaneously.
“rate” will be displayed (Figure 5, Item D).
6. Use the UP or DOWN arrow buttons to change
the RATE setting in seconds.
To change the RATE in minutes (Figure 5, Item
E), press the PROGRAM button within 10 sec-
onds of setting the seconds, then use the UP or
DOWN arrow buttons to increase or decrease the
time.
shot (steam shot time)
8. Press the PROGRAM button again and SHOT
will be displayed (Figure 5, Item F).
9. Use the UP or DOWN arrow buttons to increase
or decrease the time (Figure 5, Item G).
10. Press the SINGLE SHOT button to store the
changes and exit the PROGRAM mode.
to Change the display from
Fahrenheit (F)
to
Celsius (C) , press and hold the
uP
arrow and the
ProGraM buttons simultaneously for three seconds.
Repeat the process to reverse.
00:10
ChaNGe (F) Fahrenheit or (C) Celsius
Depending on operation, change (F) Fahrenheit to (C)
Celsius or (C) Celsius to (F) Fahrenheit.
Programming