To install the product:
1. Measure 700mm from the floor level up the wall, Mark this measurement
with a pencil.
2. Place the bottom edge of the wall bracket on the 700mm mark, level using a
spirit level and mark and drill the x3 fixing holes.
3. Using the correct wall fixings screw and fix the wall bracket in place.
4. Locate the x3 slots in the rear of the product, carefully align these slots with
the prongs on the wall bracket, lift and slot the product into place.
5. Locate the power cable socket on the bottom right hand side, underneath the
hearth on the fire, and plug the power lead in.
6. Keep the appliance at least 15cm (6inches) from side walls and any other
objects, to permit a good air circulation.
7. The product is now ready to use.
Operating Instructions
Once the electric heater has been properly installed and connected to a ground
electrical outlet, it is ready to operate.
Note: Ensure the circuit breakers for the power supply are turned on.
The heater controls are located right of the heater outlet.
Control Panel
LED Screen
Remote Control
O/I:
Press this switch, the unit power-on. When the O/I switch is turned off, all
other functions will stop even though the buttons may be in the ON position.
: Press this button, the unit will enter standby mode. The unit will beep and
the indicator light will be on. Then you can select the following functions as
desired. Press again to turn off the heater.
