6
LED worklight
When the unit is switched on, the LED worklight also comes on to
ensure better vision and to make working in dark areas safer. The
worklight goes out when the TSG system is released.
Power Consumption LED
This LED indicates the amount of battery power available for your
task. At activation the LED will glow as detailed below.
During operation the LED will alter according to the amount of load
being applied.
• Green light: the battery remaining power is above 60%
• Yellow light: the battery remaining power is between 30% to 60%.
• Red light: The battery remaining power is less than 30%. Re-
charge the battery as soon as possible.
Belt clip
The belt clip is used to assist to
clip the tool to your waist belt
while working. Install the clip to
the drill by locating the belt clip
tabs in the slots in the drill and
tighten the screw to fix the clip
firmly. (fig. J)
CAUTION!
• When using the belt clip, ensure the tool is secure
and cannot drop from the waist belt. If the power tool is
dropped, it may lead to an accident.
• When carrying the tool when hooked to your waist belt,
do not fit any type of accessory to the chuck of the power
tool, it may lead to accidental injury.
Drill overload
This drill is fitted with overload protection.
If the drill is
excessively forced, or the task being performed is too great for the
drill, the drill will automatically go into an overload mode. When the
drill goes into overload, the drill will automatically and suddenly STOP.
To reset the overload, simply remove all pressure from
the TSG system and then reapply pressure on the TSG
system to restart the tool.
Resume work after the overload
has been reset, but reduce the load by using a smaller drill bit or re-
sharpen the existing drill bit and reduce the amount of force placed
on the drill.
If the drill is set to High speed on the gear
selector, consider changing to low speed selection.
CAUTION!
Do not continue to overload the drill and
constantly reset the overload. Doing this will cause the
battery cells to overheat.
Temperature cut out
If the drill is constantly overloaded, or the drill is used constantly
at maximum rating in high ambient conditions, the battery cells
may over heat causing the battery pack to shut down.
When this
occurs you will need to immediately stop drilling and
allow the battery cells to cool.
NOTE:
• The drill will not restart until the battery pack has
cooled.
To reduce the temperature of the cells remove the
battery pack from the drill and place the battery pack in a free air
environment, out of direct sunlight or any other heat source.
• DO NOT force cool the pack in any way.
Do not place in
refrigerators or freezers. When the battery pack has cooled down
it can again be used to operate the drill, as long as the load or the
conditions causing the original excessive temperature has been
corrected.
Low voltage cut out
This tool is fitted with a low voltage cut out feature to assist in
providing a long life to the battery.
When the battery is close to the pre-set minimum low voltage level,
the power consumption LED will be red and the tool will turn off.
You will then need to insert either a fully charged battery pack into
the drill or recharge the existing battery pack.
Note:
Attempting to restart the tool without either recharging the
battery or installing another battery (with charge) will lead to drill
restarting and then stopping again, after only a few seconds of
operation.
J
Touch_IM_ED8.indd 6
22/10/13 4:39:55 PM
