909 PS26W, Инструкция по эксплуатации

Страница: 10 / 20

10
Connecting the J handle to the upper shaft
1. Lay the pole saw upper
shaft down so that the petrol
tank is resting on a secure
surface, or on the ground.
2. Insert both of the mounting
screws (+ one flat washer)
through the mounting
bracket, with one of the
screws going through the
screw hole in the J handle.
3. Once the screws are in
position, place the mounting
bracket with the J handle in
position onto the upper shaft.
4. Place the second mounting
bracket on the opposite
side so that both screws go
through the mounting bracket
securing the J handle into
position.
5. Secure the mounting brackets by adding the nut and
2 washers on each side of the bracket loosely.
Note: It is suggested to loosely secure the nut and washers
first so that the handle can be placed into the most
appropriate and comfortable position for use.
6. The J handle generally sits best so that the top bar of the
handle is on the same side of the pole as the Key Start
switch.
IMPoRTANT: Secure and
tighten the nuts.
Connecting the lower
shaft to the upper shaft
1. Loosen the shaft locking
knob. Then pull out the
shaft lock pin (11) and insert
the lower shaft (10) into
the upper shaft (9). Rotate the lower shaft until the pin
locates positively into the hole in the upper shaft.
Note. When rotating the shaft the middle drive shaft needs
to engage so it may require up to a full turn to engage both
the middle drive shaft and to
locate the shaft lock pin.
2. Tighten the shaft locking
knob (18), using the 4mm
hex key (supplied) to secure
both shafts in place.
3. Using the 4mm hex key
check the connector clamp
screw is tight.
Adjusting the
shoulder strap
The shoulder strap (8) can be
attached to the pole saw by
clipping the carabiner on the
shoulder strap to the shoulder
strap attachment (31) located
above the key start switch.
Adjust the shoulder strap accordingly so that it is comfortable
to use and supports some weight of the pole saw.
Adding chain oil
WARNING. Never start work
unless the chain and bar are
lubricated.
Note: Always make sure the
engine is turned off before filling
the oil.
1. Place the pole saw so that
the oil cap is facing up.
Untwist and remove the oil tank cap.
2. Fill the tank to approx 80% capacity with a premium
blend of Bar and Chain Lubricant.
3. Replace the cap and wipe up any oil spillage.
2
1
3
1
4