909 CK14DD, Инструкция по эксплуатации

Страница: 9 / 36

9
•
After long working periods external metal parts and
accessories could be hot.
• Do not force the saw; let the tool do the work at a
reasonable speed. Overloading will occur if too much
pressure is applied and the motor slows resulting in
inefficient cutting and possible damage to the motor.
• Always remove the battery pack before making any
adjustments or maintenance, including changing the
blade.
WARNINGS. Before connecting a tool to a power source
(mains switch power point receptacle, outlet, etc.) be sure
that the voltage supply is the same as that specified on the
nameplate of the tool or charger. A power source with a
voltage greater than that specified for the tool can result in
serious injury to the user, as well as damage to the tool. If
in doubt, do not plug in the tool. Using a power source with
a voltage less than the nameplate rating is harmful to the
motor.
WARNINGS. We recommend the use of a residual current
device with a residual current rating of 30mA or less.
Additional safety rules for rotary tools
WARNING. The use of an accessory or attachment, other
than those recommended in this Instruction Manual, may
present a risk of personal injury.
• Do not use a disc marked with a lower RPM than that of
the maximum no load speed shown on the rating label.
• Always wear eye, ear and breathing protection.
• Do not apply too much pressure when grinding,
cutting, etc.
• Keep your hands well clear of the cutting devices.
• If possible, always use clamps or a vice to hold
your work.
• Always switch off before you put the tool down.
• Ensure that the lighting is adequate.
• Do not put pressure on the tool, such that it slows the
motor down. Allow the attachments to work without
pressure. You will get better results and you will be taking
better care of your tool.
• Keep the area free of tripping hazards.
• Do not let anyone under 18 years operate this tool.
• Only use accessory bits in good condition.
• Before drilling, check that there is sufficient clearance for
the drill bit under the workpiece.
• Do not touch the attachments after operation.
They may be very hot.
• Keep your hands away from spinning parts.
• Rags, cloths, cord, string and the like should never
be left around the work area.
• Support the work properly.
• If you are interrupted when operating the tool, complete
the process and switch off before looking up.
• Periodically check that all nuts, bolts and other fixings
are properly tightened.
• When using the tool, use safety equipment including
safety glasses or shield, ear defenders, and protective
clothing including safety gloves. Wear a dust mask if the
rotary tool operation creates dust.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this Manual. All persons who use
and service the machine have to be acquainted with this
Manual and must be informed about its potential hazards.
Children and frail people must not use this tool. Children
should be supervised at all times if they are in the area in
which the tool is being used. It is also imperative that you
observe the accident prevention regulations in force in your
area. The same applies for general rules of occupational
health and safety.