The ‘Hilltopper-20’ Transceiver K1SWL rev. 15 October 2018
18
12) With the unit upside down, rest it on something so controls are held above the work
surface, set a spacer over each hole, carefully lay the cover on, then push the remaining
⅝
”
screws through the holes and spacers. Use a screwdriver, first turning counter-
clockwise until you feel each one seat, and then turn clockwise to tighten.
13) Install knobs on the three controls, using a small slot screwdriver on the setscrews.
Space the knobs slightly above the panel to prevent ‘rubbing’. The tuning knob must be
just high enough to allow the detent switch on the rotary encoder to function.
(
This completes assembly of the kit
.)
