PRO-150 V1.0 11/18
Page 20
www.4qd.co.uk
Parameter 11: Reverse beeper
There is an on-board sounder which can be made to beep in reverse. This
parameter turns the beeper on/off.
Parameter 12, 13 and 14: Pot / Input Learn
These parameters allow you to define how the speed pot and direction switch affect
the operation. These values are not entered via the programmer, rather they
change as the pot or other input is moved to the desired value, and are captured by
the SEL button.
Parameter 12: Maximum speed forward.
After selecting this parameter, adjust the pot to the position you require as full
speed forward [and the direction switch if you are using one], the display will
change to show where the pot is. Press SEL to capture the values.
Parameter 13: Zero speed.
After selecting this parameter, adjust the pot to the required zero speed position
[for joystick operation this may be in the centre of its travel]. Leave the Direction
switch in forward. Press SEL to capture the values.
Parameter 14: Max reverse (or zero speed).
If you require single ended operation, after selecting this parameter adjust the
speed pot to maximum and set the direction switch to reverse. Press SEL to
capture the values.
If you require joystick operation, after selecting this parameter adjust the pot to the
position you require to be maximum reverse speed and press SEL to capture the
value.
Using joystick operation a direction switch is not needed.
Note:
The Pro-150 is set as standard for a 10K pot but will accept 5K to 15K,
however, changing the pot value may affect slightly the speed range. Parameters
12 and 13 allow you to fine tune this.
You can also define whether reverse is with the switch open or closed. Whether
you want single ended or joystick operation. If you are using a voltage input, these
parameters allow you to calibrate the Pro-150 to your input.
You will normally have to adjust all three of these parameters.
Programming end
When you have finished programming, you need to store the new values. To save
the adjustments use the + button to increment the display to 14 and beyond to PG,
then press SEL
If you switch the ignition off during programming, any changes will be lost.
