© 2008 4IPNET, INC.
11
4ipnet EAP100 User’s Manual
3.2 Hardware Installation
Please follow the steps mentioned below to install the hardware of EAP100:
1.
Place the EAP100 at a best location.
The best location for EAP100 is usually at the center of your wireless network.
2.
Connect EAP100 to your network device.
Connect one end of the Ethernet cable to the LAN1 or LAN2 port of EAP100 and the other end of the cable to a
switch, a router or a hub. EAP100 is then connected to your existing wired LAN network.
3.
There are two ways to supply power over to EAP100.
(1) Connect the DC power adapter to the EAP100 power socket.
(2) EAP100 LAN ports are capable of transmitting DC currents via its LAN1 or LAN2 PoE ports. Connect an IEEE
802.3af-compliant PSE device, e.g. a PoE-switch, to the LAN1 or LAN2 port of EAP100 with the Ethernet
cable.
Now, the Hardware Installation is completed.
•
Please only use the power adapter supplied with the EAP100 package. Using a different power
adapter may damage this system.
•
To double verify the wired connection between EAP100 and your switch/router/hub, please also check
the LED status indication of these network devices.
