Installation Manual for VISIX Network Cameras
3xLOGIC, Inc.
• 6510 West 91
st
Avenue • Westminster, CO 80031 • (877) 3XLOGIC • www.3xlogic.com
© 2007-2012 3xLOGIC. Inc. All rights reserved. Information subject to change without notice, 3xLOGIC logo is a trademark of 3xLOGIC, Inc.
23
N
ote:
After the powering on of the camera, pressing and holding the RESET button for about 10 seconds
can reset all the parameters to the default settings.
Camera wiring diagram:
Figure 5-2
Wiring Diagram
5.2
Installation
The cube camera can be installed to wall, ceiling or table. Ceiling mounting is taken as an example in
this section; if you adopt wall mounting or table mounting, you can also take below procedure as a
reference.
Steps:
1.
Slide the right cover to remove it from the camera. Remove the fixator.
Figure 5-3
Remove the Side Cover
2.
Remove the battery cover; insert the battery; reinstall the battery cover.
Note:
If you want to install the battery, then you can take this step.
Fixator
Right cover