Hardware and Installation Manual
|
VISIX V-Series All-in-One Cameras
–
Gen I
12000 Pecos Street, Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC
24
Steps:
1).
Place the installation template included in the package on the desired installation surface.
2).
Drill two holes for the plastic anchors and a big hole for the cable lines based on the template
paper, and insert the plastic anchors into the drilled holes.
3).
Attach the provided bottom pad to the bottom of the camera body for the prevention of
water permeation.
4).
Detach the dome cover from the camera body by loosening the three screws with the
provided T20 Torx wrench.
5).
Make the screws (M4x35) ready for the installation: Insert the provided waterproof bracket
and the O-ring into the screw in a row by placing the head of the bracket beneath the screw
head by reference to the squared image on the left.
6).
Take the camera to the ceiling, and connect the necessary cables including a LAN and power
cable (or PoE cable) dropped from the ceiling to the corresponding connectors on the camera.
7).
Align the screw holes on both sides of the camera body and the installation surface, insert the
screws prepared at the step 5 into the screw holes on the camera body, and tighten them into
the plastic anchors on the ceiling with a screw driver.
8).
Adjust the angle of the camera. Refer to Adjusting Angle of the Camera for more details.
9).
Reattach the dome cover to the camera body by aligning the screws on the dome cover with
the alignment holes on the camera body. Refer to the caution below for the alignment
method.
10).
Once properly aligned, tighten the screws into the camera body with the provided Torx
wrench for the firm attachment of the dome cover. Then, remove the protection film from the
dome cover.
Bottom
Pad
O-Ring
Waterproof Bracket
Screw
(M4x35)
Torx Bolt
(M4 x 20)