720-0123-00 Rev. A
7
3DM 2 remote access requires synchronized time
When accessing a computer remotely with 3DM 2, the system time on the remote
computer cannot vary by more than 30 minutes (including time changes due to time
zones) from the system with the 3ware controller. You will be allowed to connect
remotely, but if you click on any screen you will get the message: “
(0x0C:0x001A):
You have been logged out due to inactivity or Cookies are disabled”
To remotely
connect to a system, change the local time of remote system to match the time of
the system with the 3ware controller. See 3ware KB article 13322.
http://www.3ware.com/kb/article.aspx?id=13322
Linux/FreeBSD - 3DM2 Daemon Startup
If the 3DM 2 daemon was started when the 3ware driver was loaded, you will have
to stop and restart the daemon:
e.g. /etc/rc.d/init.d/3dm stop
/etc/rc.d/init.d/3dm start
Fedora Core 3 / AMD 64-bit – can’t update the mkinitrd file
When installing Fedora Core 3 (64-bit version) to a 3ware RAID array as primary storage,
by default FC3 uses LVM when creating the disk partitions. If you use LVM, then you will
not be able to update the 3ware driver at a later time. Updating the 3ware driver at a later
time with the mkinitrd command will cause the system to not be able to boot. See 3ware
KB article 13297
http://www.3ware.com/kb/article.aspx?id=13297
.
SODIMM Memory Module
Use only the memory that is included with the controller or one that is listed in the
compatibility chart posted in the product knowledge base.
http://www.3ware.com/kb/article.aspx?id=11748
3DM 2 Schedule/Verify Behavior
In cases when no time slot task (verify/schedule) is scheduled 3DM displays "Disabled
until at least one scheduled entry is set below." When the user schedules a new task the
system automatically sets "Ignore" for the requested scheduled.
3DM 2/CLI Array Naming
The following characters are not allowed for array names, including a space:
@ % & , ; : " ' { } | \ ~ ` * [ ] < > ( )
For Controllers using the Battery Backup Unit (BBU)
•
BIOS reports “Error 01D2 in opcode 13. Press any key to continue” This message
will appear when creating an array with cache enabled and the BBU is not read (e.g.
in testing or charging mode). Create arrays before starting any BBU tests, or create
the arrays with cache disabled.
•
The battery is defective and should be replaced if either the
HIGH_CURRENT_TEST_WARNING or HIGH_CURRENT_TEST_FAULT
messages are reported by the controller. When the battery is in this status, it may
