This product is outfitted with inlet/outlet fittings. The fittings can be attached or removed from the system without tools. Retention clips are
semi-circular in shape with three internal tabs-bottom, center and top. Tabs interlace with windows in the manifold head near each connec-
tion port. Clips are flexible and easily installed following these instructions and illustrations.
1. Insert fitting into manifold.
2. With fitting inserted into manifold port, snap clip into place beginning at the bottom window
3. Push center tab into center window.
4. Finally push top tab into top window.
How to install and remove the Inlet/Outlet Fitting using Retention Clips
Apendix A.
Step 2
Step 2
Step 3
Step 4
Step 1
Installation
Removal
Step 1
Equipment Start-up Procedure
1. Install cartridges into manifold.
2. Pressurize system by slowly turning water filtration
system inlet shut off valve to the “ON” position.
3. Close vent valve.
4. Check system for leaks.
5. Flush system in accordance with cartridge performance
data sheet or flush instructions supplied with original
system.
6. System is now ready for use.
5
Inlet Water
Shut Off Valve
Vent Valve
1. Lift up on top of retaining clip while pulling down simultanously thereby releasing the center tab, pull
bottom of retention clip down to remove.
2. Pull fitting away from expansion head.
