3M™ Multimedia Projector X75 Product Safety Guide
© 3M 2005
7
ENGLISH
CAUTION
• To reduce the risk associated with environmental contamination:
- Dispose of exhausted batteries in accordance with applicable federal, state and
local regulations.
• To reduce the risk associated with environmental contamination due to mercury:
- Dispose of lamp cartridge in accordance with applicable federal, state and local
regulations.
• To reduce the risk associated with laser radiation, which if not avoided may
result in minor or moderate injury:
- Never look directly at the laser output of the remote control or point it at other people.
- Never attempt to make any adjustments to the internal controls of the remote
control other than those described in the Operator’s Guide.
• To reduce the risk associated with explosion, and/or chemicals from a leaking battery:
- Use only with battery type AA or equivalent.
- Orient the battery's plus (+) and minus (-) terminals of the batteries according to
the markings found on the remote control.
- Do not leave the battery in the remote for an extended period of time.
- Do not heat, disassemble, short, recharge, or expose to fire or high temperature
- Do not carry batteries loose in your pocket or purse.
- Avoid eye and skin contact in the event that battery would leak
- Do not mix used and new batteries.
• To reduce the risk associated with the hot surface of exhaust loovers:
- Do not touch exhaust loovers during operation.
• To reduce the risk associated with the impact of a falling projector:
- Use only the 3M™ brand wall/ceiling mounting hardware kit if wall or ceiling
mounting is desired.
- Installation of the 3M™ wall/ceiling kit must only be performed by qualified personnel.
- Adhere strictly to the proper installation procedure as outlined in the installation
instructions when installing the 3M™ wall/ceiling kit.
- Always operate the unit on a flat, sturdy, and horizontal surface.
• To reduce the risk associated with intense visible light:
- Avoid looking directly into the projector lens while the lamp is on.
• To reduce the risk associated with tripping and/or impact:
- Position the power cord and data cable so that they cannot be tripped over.
