3M DF260-CL-CC, Инструкция по установке и эксплуатации

Страница: 8 / 11

Cartridge Change-out Procedure
CAUTION
To reduce the risk associated with property damage due to water leakage:
• The disposable fi lter cartridge MUST be replaced every 12 months or sooner at the rated capacity or if a noticeable reduction in fl ow rate occurs.
IMPORTANT NOTE:
The ice cartridge (Model HF60-S-SR5) has a yellow label and will only fi t into the head on the left side of the manifold (head has a yellow 3M label).
The Beverage cartridges (Model HF60-CL) will only fi t into the heads on the right side of the manifold (heads have a blue 3M label).
DF260-CL-CC System Shut-Off procedure:
Cartridges will need to be changed at least every 12 months or when low pressure is indicated on the manifold’s pressure gauge, whichever
occurs fi rst. Depending on local water quality, you may need to change the cartridges prior to the recommended change-out. The loss of fl ow to
carbonators or improper fi ll at the ice maker are also indicators that the cartridges will need to be replaced.
1. Shut-off ice, beverage, and coffee water inlet valves (2 total).
2. Shut-off ice, beverage, and coffee water outlet valves (3 total).
3. Replace HF60-S-SR5 (yellow label), HF60-CL (blue label), and HF8-S cartridges in the sequence shown below. Then complete DF260-CL-
CC System Pre-Start-Up procedure as shown below before starting system back up.
HF60-S-SR5 Cartridge (yellow label) Replacement:
1. Relieve pressure in the ice line by opening and closing the ice outlet fl ush valve.
2. Push and hold yellow tab to release cartridge locking mechanism while simultaneously rotating cartridge to the left.
3. Using both hands and holding the cartridge from the bottom, rotate the cartridge a quarter turn to the left and gently pull down. NOTE: A
small amount of water will drain from manifold as cartridge is removed.
4. Remove sanitary cap from new cartridge. Install with a quarter turn to the right until cartridge comes to a complete stop. NOTE: Cartridges
are keyed to fi t in proper location only.
HF60-CL Cartridge (blue label) Replacement:
1. Relieve pressure to beverage/coffee line by opening and closing the fl ush valve in between the HF60-CL cartridges.
2. Push and hold yellow tab to release cartridge locking mechanism while simultaneously rotating cartridge to the left.
3. Using both hands and holding the cartridge from the bottom, rotate the cartridge a quarter turn to the left and gently pull down. NOTE: A
small amount of water will drain from manifold as cartridge is removed.
4. Remove sanitary cap from new cartridge. Install with a quarter turn to the right until cartridge come to a complete stop. NOTE: Cartridges
are keyed to fi t in proper location only.
5. Repeat steps 2-4 for second HF60-CL cartridge
HF8-S Cartridge Replacement:
1. Open downstream valve to relieve pressure.
2. Unscrew cartridge by turning clockwise. NOTE: A small amount of water will drain when HF8-S cartridge is removed.
3. Lubricate o-ring of new cartridge with water.
4. Install by turning new HF8-S cartridge toward the right until it come to a complete stop. Do not over tighten. (never use tools to tighten
cartridge)
6