3M DBI SALA Lineman's Belt, Руководство пользователя

Страница: 6 / 28

6
"D" Size
(See Figure 5)
Belt Sizing (See Figure 5)
Y
X
4 in.
“D” Size
Minimum
Center Hole
Maximum
Minimum Center Hole Maximum
in. cm in. cm in. cm in. cm
D18 46 32 81 36 91 40 102
D19 48 33 84 37 94 41 104
D20 51 34 86 38 97 42 107
D21 53 36 91 40 102 44 112
D22 56 37 94 41 104 45 114
D23 58 38 97 42 107 46 117
D24 61 40 102 44 112 48 122
D25 64 41 104 45 114 49 124
D26 66 42 107 46 117 50 127
D27 69 44 112 48 122 52 132
D28 71 45 114 49 124 53 135
D29 74 46 117 50 127 54 137
D30 76 47 119 51 130 55 140
Where to measure to determine correct “D” size for a Lineman’s Belt:
X = Distance from waist or top of hip bone to where Lineman’s Belt is worn.
Y = Measurement is from front of hip bone around the back to the front of the other hip bone. This measurement is
the “D” size.
3.4 DONNING THE LINEMAN’S BELT: Inspect Lineman’s Belt according to
Section 5.0.
Don and fit the Lineman’s Belt as follows:
Step 1.
Wrap Lineman’s Belt around waist, above your hips. See Figure 6.
Step 2.
Lace belt tongue through buckle as shown in Figure 7. Ensure
buckle is properly secured. The Lineman’s Belt should be
comfortably snug. The tongue of the buckle must be inserted
through an existing hole. Do not punch or cut new holes into the
belt.
Step 3.
After donning the Lineman’s Belt, connect to other system
components according to manufacturer’s instructions and
Section 3.4.
3.5 MAKING CONNECTIONS: Self locking snap hooks and carabiners should be
used to reduce the possibility of roll-out. Do not use hooks or connectors that
will not completely close over the attachment object. Do not tie a knot in the
lanyard or lifeline. Do not connect snap hooks or carabiners to each other.
Follow manufacturer’s instructions for each component of the system.
Figure 6 - Donning Lineman’s Belt
CONNECTING TO THE BODY SUPPORT: Attach the
positioning strap to the side D-Rings on the Lineman’s Belt.
See Figure 8. On models with floating D-Rings, slide the
D-Rings to the appropriate position for your requirements.
Reposition or adjust D-Ring positions as required. Ensure
connections are compatible in size, shape, and strength. See
subsystem manufacturer’s instructions for more information
on making connections.
3.6 AFTER USE of this equipment, clean and store according to
section 6.0.
Figure 7 -
Secure Buckle
Figure 8 -
Connections