Table 3 – Inspection and Maintenance Log
Inspection Date:
Inspected By:
Components:
Inspection:
(See Section 1 for
Inspection Frequency
)
Certifi ed
Installer
System Label and
System Certi
fi
cate
Inspect the System Label and System Certi
fi
cate. Con
fi
rm that system use will comply with all of the
following criteria:
The System Certi
fi
cate is valid and system certi
fi
cation is current. The system should be certi
fi
ed
annually or at the intervals speci
fi
ed by the Certi
fi
ed Installer. Do not use the system if system
certi
fi
cation is not current.
The Maximum Number of Users is not exceeded.
Correct Personal Protective Equipment (PPE) will be used (including proper Lanyard Length).
Ground Clearance is still the same as speci
fi
ed on the System Label and there is no risk of collision in
the event of a fall (including Swing Fall hazards).
Traveler
Visually inspect the Traveller for damage or wear. Ensure the Traveller closes securely and can not slip off
the HLL Wire Rope, Intermediate Brackets, and Corner Brackets.
Energy Absorber
(Figure 1)
Visually inspect the Energy Absorber for signs of previous deployment. The Coils (A) should be tightly
rolled with no tearing of metal between holes.
Visually inspect the Tension Indicator (B) to ensure the HLL is properly tensioned with Shoulder Washer at
the end of the Tension Spring positioned within the Green Zone (
√
) on the Tension Label.
HLL Wire Rope
(Figure 2)
Visually inspect the HLL Wire Rope for cuts, kinks (A), broken wires (B), bird-caging (C), welding splatter,
(D) corrosion, chemical contact areas, or severely abraded areas. Wire Rope must be replaced by the
Certi
fi
ed Installer if there are six or more randomly distributed broken wires in one lay, or three or more
broken wires in one strand in one lay. A “lay” of wire rope is the length of wire rope it takes for a strand
(the larger groups of wires) to complete one revolution or twist along the rope. Replace the wire rope
assembly if there are any broken wires within 25 mm (1 inch) any swaged component.
Brackets and
End Anchors
Visually inspect all Brackets and End Anchors for wear or damage. Make sure they are securely attached to
the Anchorage Structure.
Swaged Fittings
Pull test all swages to 19 kN (4,270 lbf). Hold load for 3 minutes without any slippage.
Labels
Verify that all labels are securely attached and are legible.
PPE and Other
Equipment
Additional Personal Protective Equipment (Harness, Lanyard, etc) that used with the 8mm HLL
Permanent Horizontal Lifeline Fall Arrest/Fall Restraint System should be inspected per the manufacturer’s
instructions.
1 2
A
9513583 Rev. C
kN
19 kN
(4270 lb)
+120°C
0°C
-50°C
B
D
C
B
A
Serial Number(s):
Date Purchased:
Model Number:
Date of First Use:
Corrective Action/Maintenance:
Approved By:
Date:
Corrective Action/Maintenance:
Approved By:
Date:
Corrective Action/Maintenance:
Approved By:
Date:
Corrective Action/Maintenance:
Approved By:
Date:
Corrective Action/Maintenance:
Approved By:
Date:
Corrective Action/Maintenance:
Approved By:
Date:
