3M™ Multi-Touch Chassis Display User Guide
13
3M Touch Systems, Inc. Proprietary Information -- 37732v04
Connecting the Touch Display
CAUTION
You are cautioned that any change or modification to the equipment not expressly
approved by the party responsible for compliance could void your authority to operate
such equipment.
To connect the Multi-Touch Chassis Display:
1.
Turn off your computer. You should always turn off the computer before connecting
or disconnecting a device.
2.
Select either the DVI or VGA cable. Connect one end of the video cable to the video
connector on the display. Connect the other end to the video card in your computer.
3.
Connect one end of the touch sensor cable (
either
USB or serial) to the LCD.
Connect the other end to an available port on your computer.
Note:
Do not connect
both
USB and serial cables to the display. Choose one or the
other.
4.
Plug the power brick into the display.
5.
Connect the power cable to an appropriate grounded power source.
Testing the Multi-Touch Chassis Display
Note:
The Multi-Touch Chassis Display has a power status light and video controls
located on the back of the display. If enclosure space is tight and access is important, an
on screen display remote control (part number 30114) is an option.
Before testing your touch display, make sure all cables are connected properly. Be sure to
tighten all cable screws. After connection, turn on the power switch located on the back
of the display.
To test that the display is working properly:
1.
Turn on your computer.
2.
Make sure the video image is displayed. If it is not, check the LED to ensure that the
display is not in power save mode (amber)
3.
Make sure the video image is centered within the screen area. Use the display
controls to adjust the image, if necessary.
You can adjust the horizontal and vertical position, contrast, and brightness to better suit
your video card and your personal preference. For additional details, refer to the
Adjusting the Video Display later in this chapter.
Mounting the Multi-Touch Chassis Display
The Multi-Touch Chassis Display is designed to fit any type of enclosure. All 3M Touch
Systems chassis displays are encased in rugged metal instead of plastic, making them
easy to integrate.