3M AccuGlide II STD 3 Inch, Инструкция и перечень запасных частей

Страница: 16 / 40

11
Tape Drum Friction Brake – Figure 5-2
The tape drum friction brake on each taping head is
pre-set for normal operation to prevent tape roll over
travel. Should tension adjustment be required, turn
the self-locking nut on the shaft to vary
compression of the spring. Turn the nut
clockwise to increase the braking force, and
counterclockwise to decrease the braking force.
Adjust brake to minimum tension to prevent
excessive tape roll over travel.
Tape Web Alignment – Figure 5-1
The STD tape drum assembly is pre-set to
accommodate 72 mm [3 inch] wide tape. The tape
drum assembly is adjustable to provide alignment of
narrower tapes. If adjustment is necessary to center
the tape width on the centerline of the taping head,
(and therefore box center seam), make adjustment
as follows:
1. Loosen the locking hex nut behind tape drum
bracket on tape drum shaft. Use an adjustable
wrench or 25 mm open end wrench.
Note – Excess braking force will cause poor
tape application and may lead to tape tabbing on
the trailing tape leg.
Adjustments
WARNING – Turn air and electrical
supplies off and disconnect before
beginning adjustments. Failure to comply
with this warning could result in severe
personal injury and/or equipment damage.
Figure 5-1 – Tape Web Alignment
Figure 5-2 – Tape Drum Friction Brake
2. Turn tape drum shaft in or out to center the tape
web (use 5 mm hex wrench).
3. Tighten locking hex nut to secure the
adjustment.
No other components require adjustment for tape
web alignment.
Note – To set up 72 mm tape drum for
48 mm tape, disassemble tape drum from
bracaket and install lock nut between
tape drum and bracket as shown in inset,
Figure 5-2.