8
Operation
(Continued)
Manually turn tape roll to create slack tape while
pulling threading needle through tape applying
mechanism until needle is through and tape is in
alignment with applying roller.
Excess tape can be cut with a scissors at applying
roller.
WARNING – Use care when working
near tape cut-off knife as knife is
extremely sharp. If care is not taken, severe
personal injury could result.
Figure 3-5
Figure 3-4
Place tape roll on tape drum to dispense tape with
adhesive side forward. Seat tape roll fully against
back flange of drum. Adhere tape lead end to
threading needle as shown.
Figure 3-5 – Tape Loading/Threading
Figure 3-4 – Tape Loading/Threading
Содержание AccuGlide II STD 3 Inch
