TIP - left
RING - right
Pair 1
Pair 21
Pair 5
Pair 25
3” slack
each end
8.4
Always route jumper wires below the connected post.
9.0 Accessories Installation
9.1
3M
™
4327 Series Single-Pair Probes:
a. Align pair probe and insert pins in test ports.
b. Depress clamps to allow clearance over cap heads.
Push probe forward until clamps snap behind cap.
9.2
3M
™
4328 SS 25 Pair Test Probe:
a. To operate, see instructions with unit.
9.3
3M
™
4324 SS Priority Circuit Caps:
a. Attach 3M 4324 Priority Caps on special circuits.
b. Identify circuit on matte surface of priority cap.
4324 Cap
IMPORTANT NOTICE
Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability
associated with such use.
Warranty; Limited Remedy; Limited Liability. This product will be free from defects in material and manufacture as of the date of
purchase. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above,
your exclusive remedy shall be, at 3M’s option, to replace or repair the 3M product or refund the purchase price of the 3M product. Except
where prohibited by law, 3M will not be liable for any loss or damage arising from this 3M product, whether direct, indirect, special,
incidental or consequential regardless of the legal theory asserted.
Telecommunications
6801 River Place Blvd.
Austin, TX 78726-9000
1-800-426-8688
Printed on 50% recycled paper
Litho in USA
www.3M.com/telecom
with 10% post-consumer
© 3M IPC 2001 78-8122-1737-6-A
3M is a trademark of 3M.
