7
7.2
Select proper sequence of blue labels and detach a strip of 20
labels from sheet. Carefully remove protective backing from
strip.
7.3
Remove protector tape from identification pads on the blocks
in the cabinet.
7.4
Align number 1-6-11, etc. with identification pads on left and
press into place. Align numbers 5-10-15, etc. with right
identification pads and press in place. Remove the outer liner
as shown.
7.5
Fill in Binding Post Log on cabinet door.
8.0 Jumper Wire Installation and Routing
8.1
Make sure wires have clean cut ends and bend the last
1/2” to 3/4” of wire 90°. The post slot must be in the
vertical/insertion position.
8.2
Split pair (TIP - left, RING - right) at assigned post positions.
Insert wire into port and through the post until the wire
extends out the exit port.
8.3
With a screwdriver, rotate post 90° clockwise.
Note:
Make sure screwdriver blade is fully inserted into post
slot before rotating. To remove jumper wire, rotate post
90° counterclockwise.
1/2”-3/4”
