FILTER REPLACEMENT INSTRUCTIONS
1. Place towel under filter to collect any residual water during replacement filter change-out.
2. Grasp filter and turn to the left (counterclockwise) until filter comes to a complete stop (water automatically turns off).
Water may leak momentarily from vent tube. This is normal. Gently pull filter downward to remove.
3. Remove sanitary protective cap from new replacement filter.
4. Ensure both o-rings are present on the replacement filter and are seated into grooves; moisten o-rings with water.
DO NOT use any petroleum products to lubricate the o-rings.
5. Insert replacement filter into filter head assembly. Turn replacement filter one quarter turn to the right (clockwise)
until it stops. When fully engaged, the top surface of the filter will be flush with the bottom of the filter head assembly.
(See Figure 5)
6. Open faucet and run water for a minimum of 4 gallons (approximately 2 minutes). While system is flushing, check for
leaks. Repair any leaks as needed before continuing.
Close filter system faucet. System is now under pressure and can be inspected for leaks. Repair any leaks as needed
before continuing. The system is now ready for use.
CAUTION
To reduce the risk associated with property damage due to water leakage:
•
The disposable replacement filter
must
be replaced every twelve (12) months, at the rated capacity or sooner
if a noticeable reduction in flow rate occurs.
Collet
Backstop
“Using Push-In Fittings”
To Attach Tubing
(1) Push tubing in as far as it will go.
(2) Tubing must be inserted past o-ring and hit
backstop.
Pull tube to ensure it is secured.
To Release Tubing
(3) Push in collet to release tubing.
(4) With collet held, pull tubing straight out.
To reduce the risk associated with property damage due to water leakage:
• Ensure all tubing and fittings are secure and free of leaks.
CAUTION
Figure 5
INLET
Push In
Push In
OUTLET
10.Align lugs of filter with head assembly and insert filter into
head assembly. Turn filter to the right (clockwise) until it stops
(about 1/4 turn). The filter is now installed. (See Figure 5)
11.Turn on cold water supply valve and open faucet to flush air
from the system. Run water for a minimum of 4 gallons (ap-
proximately 2 minutes) to flush system.
Close the faucet. The system is now ready for use. System
is now under pressure and can be inspected for leaks. Repair
any leaks as needed before continuing.
Содержание 3MDW201
Страница 2: ......
