3M 3M-Matic 8000a, Инструкция и перечень запасных частей

Страница: 32 / 176

NA - ENG
April 2016
3M-Matic ™ 8000a-8000a3
Page 20
7.7 Completion of Taping Heads
See Manual 2 or 3 for Complete
Instructions:
1. Place the Upper Taping Head in
a convenient working position
2. Use Figure 7-8 and tape threading
label. Position the tape supply roll
so the adhesive side of tape is
facing the front of the taping head
as it is pulled from the supply roll.
3. Attach the threading needle to
the end of the roll. Guide the
threading needle around the
wrap roller (Position 1) then
back around the one-way tension
roller (Position 2).
4. Continue pulling the threading
needle down and guide it
between the two (2) rollers on
the apply arm (Position 3).
5. Pull the threading needle down
until the tape travels between the
apply plate and the ears of the
apply arm (Position 4) until it
extends past the applying roller.
When properly threaded the
adhesive side of the tape should
be facing the knurled rollers at
position 2 and also position 3.
6. Cut away any excess tape and re-
peat steps for Lower Taping Head.
Important – Do not cut against the
apply roller - roller
damage could occur.
7.8 Outboard Tape Roll Holder
If you intend to use the outboard
tape roll holder, proceed as follows:
1. Remove the lower taping head
from the machine.
2. Remove the tape drum bracket
assembly, stud spacer, and fast-
eners from the lower taping head.
3. Install alternative wrap roller and
bracket on the head in place of
tape bracket. Replace lower
head into machine.
4. Install and secure tape drum
bracket assembly on the entry
end of the lower frame
(as shown in Figure 7-9).
7.9 Preliminary Electric Inspection
Before connecting the machine to
the mains please carry out the
following operations:
7.9.1 Make sure that the socket is pro-
vided with an earth protection
circuit and that both the mains
voltage and the frequency match
the speci fi cations on the name plate.
7.9.2 Check that the connection of the
machine to the mains meets the
safety regulations in your country.
7.9.3 The machine is fi tted with a main
switch and a circuit breaker.
The user should check that the
electrical settings of the machine
are compatible with all the
components of the mains system.
7.10 Machine Connection to the Mains
For technical speci fi cations:
See Section 4 - Speci fi cations
- Push the LATCHING EMERGENCY
STOP BUTTON.
- The main switch turned OFF (O).
Connect the power cord supplied with the
machine to a wall socket using a plug which
complies with the safety regulations of your country.
One Way
Tension
Roller
Tension
Wrap
Roller
Knurled
Roller
Wrap
Roller
Applying
Roller
Threading
Needle
#1
#2
#3
#4
Figure 7-8
Figure 7-9
7. Installation
(continued)