3i Corporation Pegasus NX, Руководство по установке

Страница: 35 / 49

31
Double-Mode: Normally Close (N.C.) Contacts without End
of Line (EOL) Resistor, with Tamper Recognition
To view the full sensor or detector wiring, click here
Double-Mode: Normally Close (N.C.) Contacts with End Of
Line (EOL) Resistor, with Tamper & Wire Fault Recognition
To view the full sensor or detector wiring, click here
Double-Mode: Parallel Connection
To view the full sensor or detector wiring, click here
Once sensor(s) or detector(s) is/are connected by using any connection mentioned in the above table, selecting the
same connection type in Pegasus™ Studio is required.
For Example:
Two sensors are connected to Pegasus™ NX in Double-Mode: Parallel Connection. In Pegasus™ Studio, under
General Settings > Input , select Double Mode – Parallel Wiring .