Cut two 1” pieces of rubber trim, and then insert them in the slots of 20x20 aluminum
bars using a flat-head screwdriver. The acrylic panel can then be inserted inside the
rubber trim which is inside the slots. Typically you’d want to do this on the horizontal
20x20 beams, although theoretically it would work just as well using the vertical
beams.
Rubber Trim Piece Distribution
3. Tight the t-nuts on the Braces
Assembly of the front and left-side panels is now complete so any t-nuts that were
loosed during those steps can now to be rightened. The printer should now have the
front and left-side panels installed.
Copyright 2018 3DUpfitters
10
