Higher Temperature = Less Cold Air
Pro Tip: measure your current temperatures before attempting to make any changes.
We get support calls saying "my enclosure is too hot" or "too cold,” but they didn't
measure the temperature. Without measurements, it's impossible to tell if a printing
problem is temperature-related or not.
11. Tips and Tricks
On some surfaces the enclosure can slide around a bit. In
those cases try using thin double sided tape on the corners to
hold it in place.
Another issue is the magnets in the door are strong. You can
either use two hands to open the door, one holding the
enclosure and another to open the door, or reduce the a
ff
ects
of the magnet by adding a piece of black electrical tape to the
side of the strike plate that contacts the magnet. You’ll need
to adjust the location of the magnetic latch by loosening the
wood screws, moving the latch, and retightening.
Copyright 2021 3DUPfitters LLC
17
