3. Back Panel
The back of the enclosure will be a little more
complicated since it contains a door. Start by
attaching the back panel to the front and left-side
panels. The four corner connectors are mirror
images of the front. The large hole is either for the
fan, the option of an air filter (purchased
separately), or completely covered up by printing a
cover on Thingiverse. On each side are “mid-panel
corner connectors.”
Next, assemble the back door using the same
techniques as the front door, i.e., hinges, latch
mounts, and strike plates. The main di
ff
erence is
that the strike plates will need to be squeezed in to
fit the smaller thickness of the back panel v.s. The
front panel.
Finally, attach the fan confirming the direction of the
fan’s air filter to pull air OUT of the enclosure. The
illustration to the right shows the fan attached to the
optional charcoal filter. Attach
using M4 cap head
30mm or 40mm screws depending on the depth of the
particular fan.
Copyright 2021 3DUPfitters LLC
11
