3DUpFitters CR-10 Max Enclosure Kit, Инструкция по эксплуатации, Страница: 13 / 23

4. Assemble Back
The back of the enclosure when viewed
from the back is shown to the right. The
four corner connectors are mirror images
of the front. The large hole is either for an
air filter (purchased separately) or can be
covered up 3D printing a cover using M4
10mm screws. (There’s a link to the cover
on the product page.)
On the top and on each side are “mid
panel corner connectors”, which are
basically simple L-shapes.
If assembling the Charcoal Air Filter, confirm the
direction of the fan’s air filter by plugging it into a USB
power supply before attaching to the filter and back of
the enclosure using M4 cap head 30mm or 40mm
screws depending on the depth of the particular fan.
The air filter should look like this after being attached.
Note that its easier to insert the screws from the
inside, and put the nuts next to the filter housing.
Copyright 2021 3DUpfitters LLC13