3Doodler Creater, Руководство пользователя

Страница: 12 / 21

10
3C. Plastic may be wrapped
around the Drive Gear.
Remove Maintenance Cover
using Mini Screwdriver
provided in the box.
Use the Mini Screwdriver
or Unblocking Tool to lift
and release Plastic from the
Drive Gear and out of the Pen
through the open area beneath
the
Maintenance Cover or
from the Plastic Loading Port .
Mini
Screwdriver
Maintenance
Cover
Nozzle may loosen with
continued usage (or in transit).
While
Pen is hot ( BLUE or
GREEN Light on), gently turn
Nozzle clockwise to tighten
it using the Mini Spanner
provided. Stop tightening once
you first feel resistance so as
to avoid over-tightening the
Nozzle and breaking it.
A. Click either the FAST or SLOW button once.
B. If Step A does not solve this problem, please unplug your
3Doodler and then plug it in and try again.
5. My Plastic won’t stop extruding.
4. My Plastic is leaking from
around the Nozzle.
While the Pen is on and hot ( BLUE or GREEN Light ), double click
either the FAST or SLOW button. Light
will start flashing to signal
the Plastic is reversing. Once the Plastic stops reversing, it is safe
to remove it from the Pen by gently pulling on the back of the
strand.
If Plastic is too short to reverse, see Section 3, Step 3B.
6. How do I reverse my
unused Plastic?
Snip the ends of your Plastic now for easier loading
and Doodling later.
It is possible that the Plastic is either too short to reverse all the
way out of your 3Doodler , or that the Plastic has moved past the
Pen’s Drive Gear system.
You will be able to check for these issues by looking through the
Maintenance Cover .
7. I have reversed my Plastic but
cannot get it out.
For both of these issues, you can try the following options:
• Insert a new strand of Plastic or Unblocking Tool to push the
remaining Plastic through while Pen is ON and extruding.
Plastic reversed, but too short to take out and no longer in
contact with the Drive Gear .
TIP
Mini
Spanner
Plastic is beyond Drive Gear.
Or
• Remove Nozzle and use Unblocking Tool to push Plastic out the
back of the Pen . (See Section 3, Step 3B).
Unblocking Tool