2
GETTING STARTED
Figure 2.41: Feeding filament into filament drive
•
Click the “
↓
” command on the Repetier-Host interface (Figure 2.38) to extrude
50
mm
of filament through the filament drive at the speed of 100
mm/min
.
•
Continue gently pushing the filament downwards until you feel the pulling from
the extruder motor.
•
If needed, click the “
↓
” command again to extrude out more filament until you
see a steady stream of melt filament extruded out of the extruder nozzle. (Figure
2.42)
38
