page
36
... print your plane | www.
3DLabPrint
.com
We highly recommend to test the power and function of the rudder, ailerons and flaps now.
Of course you can use your trusted solution for servo pushrods...
Center servo to its neutral position (use your RC system or servo tester) and attach the
included servo arms.
Make Z bend on the end side of the wire then insert it in to the rudder arm hole, then use
some gauge or just pen and mark the position of the servo arm. Cut the wire and make Z
bend. Release servo and slide the Z bend wire in and put the servo again in rudder servo slot
in vertical stabilizer.
Remember that you must slide all servo cables in to the „servo cable tunnel“ and the servo
cable extension must reach the battery/receiver comparment in the nose of the fuselage.
Now mount vertical stabilizer/rudder using two self tapping screws to mount it to the
horizontal stabilizer again.
