3DAeroventures Micro SportCam, Руководство по сборке

Страница: 15 / 40

Step 2.4 Assemble Your Preferred Landing Gear
Step-by-Step Build Guide (cont’d)
2.4.1 Main Gear Tire Hub 1 and Main Gear Tire Hub 2 are designed to be inserted into
each open side of the Tire-TPE component. Insert Main Gear Tire Hub 1 into
one side of the TPE Tire, apply a small amount of CA glue to the mating face of
the hub and insert Main Gear Tire Hub 2 into the other side of the TPE Tire.
2.4.2 Main Gear Tire Hub 1 has a recess in it for the
M3 x 0.5mm Thread x 15mm long screws.
Insert a screw into each tire and screw them
into the hole in the Main Gear Strut. Make
sure you do not over-tighten the screw so the
tires can turn freely. Apply a drop of CA glue
and accelerator where the screw exits the
inside of the Main Gear Strut.
www.3daeroventures.com
3D
Aeroventures
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
w�w�3�A�r�v�n�u�e�.�o�
- 1� -
Fuse 1 (11g)
Tire- TPE
(Total Main Landing Gear Weight 12g)
Main Gear Tire Hub 1 (PLA)
Main Gear Tire Hub 2 (PLA)
Fuse 2 (15g)
Fuse 3 (7g)
Horiz Stab L (2g)
Vert Stab (2g)
Canopy (5g)
Servo Tray (2g)
Horiz Stab R (2g)
Main Gear Strut (PLA, ABS, or PETG)
You have the option to setup the Micro SportCam in a taildragger configuration or
a tricycle gear configuration. Here are some important notes about the landing gear:
1. The Main Gear Strut is the same for both configurations. It will just be glued into
a different location on the fuselage depending on which configuration you choose.
2. The TPE Tire is the same for the main gear and the nose gear, but you also have the
option of a larger diameter Bush Wheel for the taildragger configuration.
3. The nose gear uses different Tire Hub parts which have a smaller diamater through
hole for the nose gear wire.