ZPrinter
®
150 / ZPrinter 250 User Manual
Post-Processing
41
All Rights Reserved
11/1/12
Dry the Part
Allowed to air dry at room temperature, the part will be fully dried within 24 - 48 hours.
For faster drying, the parts can be placed in an oven set to 7° C for 3-4 hours. This also helps guarantee
maximum whiteness of the parts.
Clean up
Any overspray is easily cleaned up with a wet cloth or sponge.
The salt solution may be covered and reused for up to one week. Always check the solution before any
subsequent uses - if the solution is cloudy or discolored in any way, discard it and make a fresh batch.
The salt solution may be safely disposed of by pouring down a sink drain and flushing with plenty of water.
4.2 Post-Processing With Z-Bond
This section describes post-processing a part using Z-Bond Instant Infiltrant. The infiltrant soaks into the
newly-printed part and bonds the printed powder together. This both strengthens the part and gives it more
durability.
Z-Bond is available in larger bottles for use in the
dipping
method. For parts with
delicate features, smaller bottles of Z-Bond are available for
drizzling
onto a part.
We’re always testing new materials and combinations, so check our Web site for
the latest complete information regarding post-processing materials, techniques,
Best Practices, and material storage guidelines. All this information, plus shop-
ping for consumables, is at
Safety Precautions
•
Read and understand the
Material Safety Data Sheet
before using or
handling this product.
•
Wear a lab coat or smock, gloves, face shield, or goggles.
•
Apply in a well-ventilated area.
•
Specialized containers are recommended for applying Z-Bond. Have a catch pan, waxed paper, or
plastic drop cloth available for catching spills.
•
Label disposal materials and dispose of according to the label instructions.
•
Wear a dust mask when sanding finished parts.
•
Z-Bond reacts with water and ambient moisture. Once a bottle has been opened, it is recom-
mended that the product be used within 30 days. Avoid all contact with water and avoid use under
high humidity conditions. If Z-Bond is exposed to excessive humidity, it will thicken up and become
unusable for infiltration.
•
Store Z-Bond in a cool, dry area.
This section covers the following topics:
•
•
Section 4.2.2, ’Post-Processing Using the Dipping Method’
•
Section 4.2.3, ’Post-Processing Using the Drizzle Method’
4.2.1 Preparation
Before you begin infiltrating your part, make sure the part is completely free of powder. See Section 2.10.2,
’Fine Powder Removal’ for more details. Follow these preparation guidelines:
•
Wear a lab coat or smock, safety glasses, and a pair of the high quality gloves from the Startup Kit
(or 2 pairs of lightweight disposable gloves).
