5
MACHINE USE
5.1 Loading 3D Prints
Before loading 3D prints, make sure that the machine is turned off. Open the protective glass straight up and put the 3D prints
to be cleaned inside the blasting chamber. When the prints are loaded, close the protective glass.
Figure 3: Open the protective glass straight up and put the prints in the blasting chamber.
WARNING: DO NOT, AT ANY TIME, WHEN THE LID IS OPEN TURN ON THE WATER AS THE HIGH-PRESSURE WATER
JET CAN CAUSE SERIOUS INJURY.
5.2 Cleaning 3D Prints
1. Turn the machine on by pressing the left button on the machine's front.
2. Turn the wiper on and off by pressing the middle button on the machine's front.
3. Use the water blasting gun inside the chamber to turn on and off the water jet.
4.
CAUTION: Only shoot water against the back of the chamber as the high-pressure water may damage the
lid seal and cause water leakage
Keep the 3D printed part you are cleaning at a distance of 10 cm / 3.9 inch from the blasting gun nozzle and avoid using the
jet at fine details for any longer period of time as it may affect the 3D-print negatively.
5. You can change the water pressure by rotating the nozzle.
Figure 4: Rotate the nozzle to change the water pressure.
6. To dry prints with pressurized air, press the right button on the machine's front to switch from water to air blasting. Use the
air blasting gun inside the chamber to turn on and off the air stream.
7. When done, wait for the compressor to turn off automatically and then turn the machine off by pressing the left button on
the machine's front.
3D Systems, Inc.
8
p/n 74-D002, Rev. A