1
3D SYSTEMS, INC
.
1
PREPARING FOR INSTALLATION
Use this guide to help you prepare your facility for the installation of the ProX
®
DMP100.
As you satisfy the requirements for each section in this guide, you need to complete the “Facility Requirements Checklist -
ProX® DMP100” on page 15. You must complete this checklist and send it to 3D Systems when you’re ready to have your
equipment installed.
You will find all contact information for 3D Systems’ service and support on page 16 .
SAFETY PRECAUTIONS
Please review all safety information in the safety section of the ProX
®
DMP100 User Guide.
WHEN YOU ARE READY FOR INSTALLATION
Caution: After you receive your equipment, do not allow anyone to connect electrical power, compressed
air, or gas to any of these devices. This must only be done by your 3D Systems-certified Customer Support
Engineer (CSE) during installation .
Attempts to install equipment or auxiliary equipment by non-3D Systems-certified personnel could void the
warranty and result in serious injury and equipment damage .
Caution: NEVER unpack, assemble, or connect any component of the shipment without the aid of a qualified,
3D Systems-certified Customer Support Engineer (CSE). 3D Systems accepts no responsibility for damaged,
defective, or incomplete systems uncrated by anyone other than a 3D Systems-certified CSE.
Caution: Once the printer is installed, it cannot be moved without the aid of a qualified, 3D Systems-certified
Customer Support Engineer (CSE) . 3D Systems accepts no responsibility for damage to the printer by anyone
other than 3D Systems-certified CSE.
Moving the printer may affect settings (alignments, calibration...). Contact your 3D Systems-certified CSE to
check the operation of the printer after moving .