14
When you select “RUN,” the following sequence will begin:
RUN
• Fluid’s Valve Motor will be ON for 15 seconds and
is waiting to detect end of the travel.
• If valve is in the correct position and ready, it will con
-
tinue to the next step.
• Material will be transferred to the cart until:
• Cart is full, or
•
Pump is running for 2 hours (time out)
•
Until there is no more material to transfer to the
cart.
• If cart is completely empty, pump material until
3 minutes time-out or level is OK; it will con
-
tinue the rest of the pumping routine.
• There is a minimum level required in the cart in order to be able to heat and mix the material. Currently this
level is just below 1/4 of the cart. If the level is more than the minimum “Status” will display. If there is no
more resin to transfer and level in the cart is still too low, the system will display an error and it will be halted.
Goes ON and OFF in
Sync with Heater
• RUN status screen:
• Heater and Mixer will run with previously programmed parameters if there is minimum level of material in
the cart.
• Current material temperature; minimum material level OK, cart full and programmed settings for Mixing and
Heating ON/OFF/IDLE will be displayed
Cart Status
Resin Temperature
