3Com Switch 8807, Справочник по командам

Страница: 270 / 1099

268 C
HAPTER
17: Q
O
S C
OMMANDS
The system can set service parameters for the matched traffic in one of following
modes:
1 Employ the service parameters automatically allocated by the switch. Upon
receiving a packet, the switch allocates a set of service parameters for it according
to a specific rule. To choose this mode, you should select the
auto keyword in this
command.
2 Choose service parameters from the "DSCP + Conform-Level ->
Service-parameter" mapping table according to packet DSCP value and conform
level. To choose this mode, you should select the
remark-policed-service
trust-dscp keyword in this command.
3 Choose service parameters from the " DSCP + Conform-Level ->
Service-parameter " mapping table or " EXP + Conform-Level ->
Service-parameter " mapping table according to user’s DSCP priority or EXP value
of MPLS packets and packet conform level. To choose this mode, you should select
the
remark-policed-service dscp dscp-value parameter in this command.
4 Customize a set of service parameters. To choose this mode, you should select the
remark-policed-service untrusted dscp dscp-value cos cos-value
local-precedence local-precedence drop-priority drop-level parameter in this
command.
n
■
The "DSCP + Conform-Level -> Service-parameter" mapping table and " EXP +
Conform-Level -> Service-parameter " mapping table here is that for the
conform level 0.
■
Before selecting the second or third mode, you should make sure that you have
configured the "DSCP + Conform-Level -> Service-parameter" mapping table
and " EXP + Conform-Level -> Service-parameter " mapping table. For more
information about this mapping table, see the
qos conform-level , dscp and
exp commands.
Related command: display qos-interface traffic-priority .
Example
# Choose auto service parameters for the packets which match the permitted rules
in the ACL 4000.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800]interface e thernet5/1/2
[3Com-Ethernet5/1/2] traffic-priority inbound link-group 4000 auto
traffic-redirect Syntax
Command Format Which Only Applies IP Group ACL
traffic-redirect inbound ip-group { acl-number | acl-name } [ rule rule [
system-index index ] ] { cpu | interface interface-type interface-number
destination-vlan { l2-vpn | l3-vpn } | next-hop ip-addr1 [ ip-addr2 ] [ invalid {
forward | drop } ] | slot slotid { vlanid | designated-vlan vlanid } [ join-vlan ] }
undo traffic-redirect inbound ip-group { acl-number | acl-name } [ rule rule ]