3Com Switch 7754, Руководство по настройке

Страница: 345 / 940

Displaying Integrated IS-IS Configuration 345
Resetting Configuration
Data of an IS-IS Peer
Displaying Integrated
IS-IS Configuration
After the above-mentioned configuration, you can use the display command in
any view to display the IS-IS running state.
By performing the following operations, you can display IS-IS link state database,
packet transmission, and SPF calculation, so as to verify IS-IS route maintenance.
Integrated IS-IS
Configuration
Example
Network requirements
As shown in Figure 79, four Switch 7750 Ethernet switches (Switch A, Switch B,
Switch C, and Switch D) are interconnected through IS-IS routing protocol. In the
network design, Switch A, Switch B, Switch C, and Switch D belong to the same
area.
Table 286 Reset configuration data of the IS-IS peer
Operation Command Description
Enter system view system-view -
Reset configuration data of
an IS-IS peer reset isis peer system-id Optional
By default, configuration data of
an IS-IS peer is not reset.
Table 287 Display and maintain integrated IS-IS configuration
Operation Command Description
Display brief information of
IS-IS display isis brief You can execute
the
display
command in any
view.
Display IS-IS link state database display isis lsdb [ [ l1 | l2 | level-1 |
level-2 ] | [ [ lsp-id | local ] | verbose ]* ]*
Display IS-IS SPF logs display isis spf-log { ip | clns }
Display IS-IS routes display isis route
Display IS-IS peer information display isis peer [ verbose ]
Display mesh group information display isis mesh-group
Display IS-IS interface
information display isis interface [ verbose ]