15
Table 15
Ethernet Port View
[4500]
interface ethernet 1/0/1
ip address dhcp-alloc
Configure a VLAN interface to obtain IP address using DHCP
Administration -> IP Setup
-> Device -> VLAN Interface
rip authentication-mode
Configure RIP-2 authentication mode and its parameters
rip input
Allow an interface to receive RIP packets
rip metricin
Configure the additional route metric added to the route
when an interface receives RIP packets
rip metricout
Configure the additional route metric to the route when an
interface transmits RIP packets
rip output
Allow an interface to transmit RIP packets to the network
rip split-horizon
Configure an interface to use split horizon when transmitting
RIP packets
rip version
Configure the RIP version of RIP packets on an interface
rip work
Enable the running of RIP on an interface
shutdown
Disable the VLAN interface
Device -> VLAN Interface
udp-helper server
Configure the relay destination server
Command
Description
Web Command
am ip-pool
Configure the IP address pool for access management on a
port
arp static
Configure the static ARP mapping entries in an ARP mapping
table
broadcast-suppression
Configure the broadcast traffic size enabled on port
Port -> Administration
description
Configure name for a port
dot1x max-user
Specify maximal on-line user number per port
dot1x port-control
Specify port authenticated status
dot1x port-method
Specify port controlled method
dot1x supp-proxy-check
Check whether user(s) access the networks by proxy or not
duplex
Configure the duplex mode of the port
Port -> Administration
enable snmp trap
Enable/disable current port to transmit the LINK UP and LINK
DOWN trap information
flow-control
Enable flow control on the Ethernet port
Port -> Administration
lacp enable
Enable LACP
Port -> LACP
lacp port-priority
Configure port priority value
Port -> LACP
line-rate
Limit the total rate of the packets delivered by interfaces
loopback
Configure the Ethernet port to perform the loopback test
Tools -> Loopback
loopback-detection
control enable
Enable loopback detection control function on a trunk or
hybrid port
loopback-detection enable
Enable port loopback detection
loopback-detection per-
vlan enable
Configure loopback detection on all VLANs on trunk and
hybrid ports
mac-address blackhole
Backhole entry, no age, can be added or deleted, and is saved
to the configuration file
mac-address dynamic
Dynamic entry, age, can be added or deleted, and is lost after
reset
mac-address max-mac-count
Limit the number of MAC addresses to be learned by an
Ethernet port
Port -> Administration
mac-address static
Static entry, no age can be added or deleted, and is saved to
the configuration file
mac-authentication
Enable the centralized MAC address authentication feature on
a specified port or globally
Command
Description
Web Command