3Com Courier, Справочник

Страница: 54 / 204

6-2 C
HAPTER
6: W
ORKING WITH MEMORY
Example: Sending
ATI5
will display NVRAM settings on your screen.
To see a complete listing of the permanent settings stored in Flas
memory see
Appendix , Flow Control Templates.
Working with RA
and NVRAM
You can change any setting just for the current session. For example
setting your Courier V.Everything modem to
AT&N8
will only allow a
connection to a remote devices at a rate of 14400 bps or lower until the
modem is reset. Once the modem is reset, the default variable connectio
rate will be re-established.
If you want the new setting to be a default, write it to NVRAM at the
same time. From the example above, you would send
AT&N8&W
to the
modem. The new default setting for your Courier V.Everything modem
will only allow a 14400 bps connection to a remote device.
To restore NVRAM factory defaults, use the AT&Fn command. See
Appendix B,
Alphabetic Command Summar
, for more information on
setting &Fn.
Saving a Phone
Number to NVRA
CAUTION: Do not include modem commands in
AT&Z
n
=
s.
Example: To store the phone number 555 6789 at position 2, type
AT&Z2=5556789
. If you want to dial the phone number you saved, type
ATDS2
.
For your modem to Command
Write the phone number (
s
) to a position (
n
) in memory. You can
store up to 10 phone numbers of up to 40 characters each in
positions 0-9.
AT&Z
n
=
s
Display the number stored in the last-dialed number buffer
ATDL?
Display the phone number stored in NVRAM at position n, where
n = 0-9.
AT&Z
n
?