3Com 4800G Series, Руководство по настройке

Страница: 192 / 1246

192 C
HAPTER
22: DLDP C
ONFIGURATION
Setting the Port
Shutdown Mode
On detecting a unidirectional link, the ports can be shut down in one of the
following two modes.
■
Manual mode. This mode applies to networks with low performance, where
normal links may be treated as unidirectional links. It protects service packet
transmission against false unidirectional links. In this mode, DLDP only detects
unidirectional links and generates log and traps. The operations to shut down
unidirectional link ports are accomplished by the administrator.
■
Auto mode. In this mode, when a unidirectional link is detected, DLDP transits
to Disable state, generates log and traps, and set the port as DLDP Down.
Follow these steps to set port shutdown mode
c
CAUTION:
■
On a port with both remote OAM loopback and DLDP enabled, if the port
shutdown mode is auto mode, the port will be shut down by DLDP when it
receives a packet sent by itself, causing remote OAM loopback to operate
improperly. To prevent this, you need to set the port shutdown mode to auto
mode.
■
If the device is busy, or the CPU utilization is high, normal links may be treated
as unidirectional links. In this case, you can set the port shutdown mode to
manual mode to eliminate the effects caused by false unidirectional link report.
Configuring DLDP
Authentication
Follow these steps to configure DLDP authentication:
c
CAUTION: To enable DLDP to operate properly, make sure the DLDP
authentication modes and the passwords of the both sides of a link are the same.
To do… Use the command… Remarks
Enter system view system-view -
Set the DelayDown timer dldp delaydown-timer time Optional
1 second by default
DelayDown timer setting
applies to all the DLDP-enabled
ports.
To do… Use the command… Remarks
Enter system view system-view -
Set port shutdown mode dldp unidirectional-shutdown
{ auto | manual }
Optional
auto by default
To do… Use the command… Remarks
Enter system view system-view -
Configure DLDP authentication dldp authentication-mode { md5
md5-password | none | simple
simple-password }
Required
none by default