360 Systems MAXX-1200-HD, Руководство по эксплуатации, Страница: 67 / 148

Page 66 MAXX-1200 Owner’s Manual
Changing Duration of Clips in a Playlist
Make sure the
EDIT
checkbox is checked in the Playlist View window. Position the cursor over a
clip and right-click. Select
EDIT DURATION
from the pulldown menu
.
Enter a duration in the
Duration window. The minimum duration is 3 seconds. The entry may be in one of these
formats.
•
Hours, Minutes, Seconds and Frames entered as HHMMSSFF
04300102 = 4 Hours, 30 minutes, 1 second, 2 frames
•
Hours, Minutes, Seconds and Frames entered as HH:MM:SS:FF
03:39:41:17 = 3 Hours, 39 minutes, 41 seconds, 17 frames
•
As a whole number along with the special characters H for hours, S for seconds, M for minutes
7H would set 7 hour duration. 31m would set 31 minutes. 15s would set 15 seconds.
NOTE
: The Clip duration is affected only within the Playlist, for this event. The duration of the
source clip is not changed. Other events containing the same clip are not changed.
Mapping GPO to Playlist Events
The MAXX-1200 has six General Purpose Outputs, referred to as GPO 1 through GPO 6. Any of
these can be programmed to go active at a pre-determined time, or o
ffset, after the beginning of a
Playlist clip. An active d uration can also be set, after which the output again goes inactive.
In all
cases, every output will go inactive when a clip ends. By default, a new clip contains no
programmed GPI output commands. Refer to Appendix A – Connector Specifications for details
on electrically interfacing to the GPO lines.
To Map a Playlist event to a GPO Line, Follow these steps.
1. Select
EDIT>CONFIGURE >GPO
.
The screen of
Figure 21
is displayed. GPO 1 through
6 are triggerable outputs. The checkboxes to the right of each selection represent channel
1, 2 and 3. GPO 6 is shown with the trigger option pulldown expanded.
a. Set the GPO of interest to
PLAYLIST
mode from the pulldown menu.
b. Set the Channel to 1, 2 and/or 3 by checking the appropriate check box to the right.
Click
APPLY
to activate the settings.
2. Check the
EDIT
checkbox in the Playlist View of the transport.
3. Place the cursor over a Clip in a Playlist. Right click on the clip. Select
EDIT GPO
. The
GPO Editor (Figure 22 ) appears.
4. Enable the GPO of interest by checking the corresponding
ENABLED
checkbox.
5. Enter an offset into the Clip to activate the GPO line in the
Offset Field
. The form of the
field is Hours, Minutes, Seconds and frames. ( HH:MM:SS:FF )
6. Enter the Duration for the GPO to remain active in the
Duration Field
using the same
format. Click
APPLY
to activate the changes.