360 Systems MAXX-1200-HD, Руководство по эксплуатации

Страница: 24 / 148

MAXX-1200 Owner’s Manual Page 23
Server Hardware Interface
Front Panel Elements
Reset (Power ON/OFF) Button
The front panel Reset button initiates start-up and shut-down of the server. Press it momentarily
to start the server. A sequence of start-up screens will appear, presenting the 3-channel graphic
user interface.
When the server is running, pressing the power button momentarily will cause the system to
begin an orderly shutdown. This can also be initiated from the GUI by selecting
START > SHUTDOWN > SHUTDOWN
. In most cases the power will shut off automatically,
however if the front panel lights begin to blink the file system has been properly closed and it is
safe to force the power off by holding the front panel button in for 4 seconds.
If the system has stopped responding to commands and will not shutdown, hold the button in
for 4 seconds to force a power down.
Do not use the rear panel switch on the power supply to shut down the server. Abrupt power
loss could cause loss of stored information. The rear panel power switch can be used to
prevent re-application of power during service procedures once the normal shut down
sequence is complete.
CAUTION
LOSS OF DATA CAN OCCUR IF THE POWER IS TURNED OFF WITHOUT A SHUTDOWN.
USE THE FOUR SECOND SHUTDOWN ONLY IF THE SYSTEM IS NOT RESPONDING OR THE
SHUTDOWN PROCESS DOES NOT TURN THE POWER OFF AUTOMATICALLY.
Indicators
Five blue LED Status Indicators appear on the front panel. The POWER, FANS, DRIVES and
SYSTEM indicators are illuminated continuously when the system is functioning normally.
GENLOCK will be off when Internal Sync is selected, and illuminated when Genlock is
selected. See the table
Front Panel Indicators on page 113 for diagnostic meanings.