4
| Honeycomb Shades UltraLift Cordless™
OPTIONAL ACCESSORIES
Optional extension brackets are used to project the back of
the shade up to 2
3
/
8
" from the mountain surface.
• Attach each mounting bracket to an extension bracket using
the nuts bolts and washers provided.
• Mount the extension bracket to the wall per the instructions
for an “Outside Mount”, using a level and making certain
that all mounting brackets are level and project the same
distance from the mounting surface. For maximum stability,
install the screws diagonally from one another.
• Install the shade per the directions for “Shade Installation”.
Spacers are available for use on windows with a projected
molding. They are
3
/
8
" thick and allow the shade to be
mounted flush with the outside edge of any standard
window molding. They are available by contacting
our Customer Care Department at 800-800-3329.
EXTENSION BRACKETS
SPACERS
Hold down brackets are used primarily on shades mounted to
doors or in motor homes. There are two small holes in the end
caps that are covered by a thin plastic layer. Use the pin on
the hold down bracket to push through the center of the end
cap and it will break through the plastic layer.
• With the shade lowered to it’s full length, place the pin of
each hold down bracket into the hole in each end of the
bottom rail.
• Mark the mounting surface, either to the side or back of the
window frame, through the holes in the hold down bracket.
Make sure the hold down brackets are level and aligned with
each other.
• Raise the shade and screw the hold down brackets into the
mounting surface using the screws provided.
• Lower the shade and flex the
hold down bracket outward
so that the pin can be
inserted into the hole in the
end cap.
HOLD DOWN BRACKETS
2"
minimum
Extension Bracket
Bolt
Nut
2"
Spacer
