3
| Honeycomb Shades UltraLift Cordless™
SHADE INSTALLATION
SHADE OPERATION
If you have not already done so, unwrap the cellophane from
around the shade. DO NOT CUT the cellophane as the fabric
or the cords supporting the shade may be inadvertently cut.
• Hold the shade up near the brackets and insert the front
clip of the bracket into the front groove of the rail.
• Make sure the shade is centered in the window opening.
• Push the rail back and up until the back clips of the bracket
are inserted in the back groove of the rail.
• Press the button on the handle to raise or lower the
moveable rails. The rails will stay in position when the button
is released.
SHADE REMOVAL
Draw the shade completely up. (See “Shade Operation”)
Push shade rail back and rotate the back of the shade down
to release.
• Rotate the back of the headrail down and carefully lift the
headrail off of the front hooks of the mounting brackets.
If the bottom rail of the shade is not level, it can be adjusted
by following the procedure below.
• When the rail is level, replace the tool and the endcap.
• Remove the right end cap
from the bottom rail.
• Pull out the section
labeled TOOL.
• Push in on the adjustment
screw with the tool and turn
to adjust the rail. Turning
clockwise will move the rail
down, counterclockwise will
move the rail up.
LEVEL THE MOVING RAIL(S) (if necessary)
