Table of Programmable Parameters
3.2
33
2N
®
SpeedRoute has no data on your provider. In that case, enter the
data manually.
LCP echo interval [0 – 3600 s]
Set the timeout after which the LCP echo should be sent.
LCP echo failures [0 - 10]
Set the count of unsuccessful LCP echo attempts after which the connection error
should be detected. Subsequently, the PPP demon is restarted. The gateway tries
to reconnect to the Internet.
Max connect failures before reset
Set the count of unsuccessful connection attempts after which the system is
restarted.
Note
n
LCP echo is a function of the PPP demon, which is responsible for
connection to the provider (LTE/UMTS - PPPoE). It sends packets in
predefined intervals and expects responses to them. When the defined
count of failed responses has been achieved, the PP demon is restarted
and tries to reconnect to the Internet.
n
As a matter of fact, LCP echo is a self-diagnostic function, which monitors
connection and is able to repair errors if any. Moreover, SMS notification is
associated with this state and so, when an error occurs, a notification SMS
is sent.
Disconnection notification [1 – 3600s]
A notification SMS is sent when the defined period of time elapses. Errors must
come in a sequence to be considered. This means that the first correct attempt
clears the counter even if the next one is wrong again.
DNS1/DNS2
The IP address of the DNSs used as assigned by the provider upon network login.
Cannot be programmed!
IP
The IP address of the default gateway used as assigned by the provider upon
network login.
Cannot be programmed!
FUP
The FUP (Fair User Policy) function is set in this menu. The maximum amount of
data to be transmitted is defined for a certain period of time. The limit is 100 GB.
One selection at least must be ticked off to make this service work. The service is
OFF by default. Exceeding leads to Internet disconnection until the counters are
reset.
