1
Sortiment
Part No.
Description
919645XX
Basic button version
919645WBXX
Buttonless version
Extending modules
Part No.
Description
913646
Lift blocking module –
blocks the lift function during
telephone line failures.
919680E
Programming tool –
interconnects Lift1 with the
2N
®
Service Tool on the PC for programming.
Description
2N
®
Lift1 Compact (hereinafter referred to as Lift1) is a robust, metal-encased audio unit
equipped with an ALARM button of the prescribed size by default. In buttonless versions, an
external button is connected as necessary. The audio unit is equipped with illuminated pictograms
to signal the connection state and an induction loop for deaf people. It can easily be wall mounted
without requiring precise wall cut-outs. It combines all the required lift communicator functions in
the basic version. A PSTN or alternative (PBX, GSM gateway) line is used for connection with the
control centre.
Operation
Press the ALARM button to activate connection. The "Wait" pictogram goes on immediately and
the "Connection established" symbol goes out when communication has been set up. You can use
automatic dialling of up to six pre-programmed numbers. Communication is accompanied by
factory announcements and/or user recorded lift ID messages.
Service and Operating Staff Instructions
In the Automatic Dialling with Confirmation mode – default settings:
DTMF charter:
Function
Confirm
to Lift1 that the call was successful. Lift1 mutes the
currently played announcement and sends its confirmation signal.
The call goes on until the call time limit is exhausted and any of the
following commands can be used.
Mute
the voice module to avoid disturbance of the operating staff
and persons in the lift.
Play
the user message if stored in Lift1.
or
Extend the call
by 30 seconds. Can be used repeatedly.
or
Terminate
the call.
